Targus AKM10US Manuel d'utilisateur télécharger pdf (Page 5)

Targus wireless keypad and opitcal mouse combo

Setting the Identication Code

After your computer detects the USB receiver you must set

the ID code between the receiver and the mouse as well as

between the receiver and the keypad BEFORE you can use

them. To do this, do the following:

NOTE: MAKE SURE THAT YOUR COMPUTER IS TURNED ON AND HAS DETECTED

THE USB RECEIVER BEFORE YOU SET THE ID CODE.

Optical Mouse

1 Plug the USB receiver into an available USB port on your

computer. The LED on the receiver will ﬂash for 60 seconds to

indicate ID search mode.

2 Press the setup key on the bottom of the mouse.

Setup Key

Power switch

When the LED on the receiver is lit, the mouse is set up with

an ID and the receiver is locked.

You are now ready to use the mouse.

Proceed to setting the ID code with the keypad.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Targus AKM10US Manuel d'utilisateur Page 5